Hanwell IM6001 - SR2 Virtual Network Configuration Prerequisites

Hanwell Smart Receiver 2 (SR2)
Instruction Manual
hanwell.com
Page 7 of 22 IM6001 - 3
3.1.1 Virtual Pre-requisites
Each SR2 requires a unique Static IP address, which should be assigned by you IT
Department.
This IP address should be accessible from the PC on which the software will run.
IP Address
For example: 192.168.1.100
_ _ _ . _ _ _ . _ _ _ . _ _ _
Subnet
For example: 255.255.255.0
_ _ _ . _ _ _ . _ _ _ . _ _ _
Gateway
For example: 192.168.1.1
_ _ _ . _ _ _ . _ _ _ . _ _ _
If the IT Department requires a MAC address in order to assign an IP address, contact Hanwell
Solutions Ltd. to request it; see Section 8.
The MAC address is also listed on a label on the ‘daughter’ PCB inside the SR2’s case, in the
format xx:xx:xx:xx:xx:xx.
