Hanwell Smart Receiver 2 (SR2)
Instruction Manual
IM6001 - 3 Page 4 of 22
hanwell.com
2 Pre-Requisites
Before installing and configuring the SR2, you should have read Document GD6014 Smart
Receiver Installation Pre-requisites which details the necessary pre-conditions for installation.
A copy of this is supplied in Section 3.
If a Radio Survey has not been completed, the SR2 unit should not be permanently mounted
to the wall until the radio reception has been tested for the proposed location.
2.1 Inventory
Your SR2 should be supplied with the following, as standard:
1 x SR2.
1 x 1m straight-through CAT5 cable.
IEC Power Cord with Locking System; see Figure 3 overleaf.
1 x UPS battery (unless an external one is to be used).
1 x External Receiver Unit (boxed separately).
USB-SP2; USB stick containing relevant manuals, including IM6001 (this document).
If you are missing any of these items, please contact Hanwell Solutions Ltd.; see Section 8.
You will also need the EMS application installed on your System.
2.2 SR2 Unit Ratings
Voltage:
Frequency:
Current:
Power:
115 – 240V Switchable
50 – 60Hz
180mA @230vAC
80W
WARNING!
To Avoid Possible Electric Shock or Personal Injury, Follow These Guidelines:
DO NOT operate this Unit without a properly grounded, properly polarised power cord.
DO NOT connect this Unit to a non-grounded, non-polarised outlet.
Caution
The SR2 Unit contains a Lead-Acid UPS battery which should never be left for extended
periods in a discharged state, to prevent damage to the battery’s cells.
To Next Page