HANYOUNG NUX NP100 User Manual

10
6-2. Function of control key
Caution
- Press the key firmly with your finger
- Do not press the key with any sharpened thing. It could cause key malfunction
Caution
● Automatic/Manual Operation Selection Method
Press the AUTO/MAN key on the front panel to choose automatic and manual operation.
On manual mode, the MAN LED will be turned on and MAN LED will be turned off for automatic mode.
The control output value can be changed continuously with the operation of ascent and descent keys.
Name Function
• Operate the current pattern number.
• Input the parameter setup value • Use when moving the parameter
• Press 2.5 seconds or longer to alternate the operation indicator mode and the
engineering mode.
• Exit running program and convert to stop.
• Exit runing MAN operation and convert to reset mode.
• Use to finish program setup mode.
• Press to move to other digit.
• Use for changing the parameter value.
• Use for moving to other group.
• Use for changing the parameter value.
• Use for moving to other group.
+
• When the program is running, press it to hold ongoing segment.
• Press it again to release the holding
+
• Exit the running segment while operating program and operate the next
segment.
• Use to change the pattern number.
• Press key to alternate P1 and P2
• AUTO : Use for changing from MAN control to Program Mode.
• MAN : Use for changing Program mode to MAN control.
• Press key to alternate AUTO and MAN.

HANYOUNG NUX NP100 Specifications

General

Brand	HANYOUNG NUX
Model	NP100
Category	Controller
Language	English