Need help?Do you have a question about the HANYOUNG NUX NP100 and is the answer not in the manual?
General| Model | NP100 |
|---|---|
| Operating Temperature | 0°C to 55°C |
| Storage Temperature | -20°C to 70°C |
| Type | PLC Controller |
| Communication | RS-485 |
| Programming Language | Ladder Logic |
| Input Type | Digital Input (DI) |
Details the available input types and their corresponding measurement ranges.
Explains the operation and functions of the various keys on the controller's front panel.
Steps to configure the controller's basic functions via the engineering mode.
Configures the input signal type, measurement range, and decimal point settings.
Guides on setting up program repeat frequency and sequence parameters.
Sets the number of times a program pattern will repeat, including limitless options.
Configures pattern number, start set value, start type, time signals, and completion modes.
Illustrates the flow for setting up and running control programs.
Sets up output types, heating/cooling control, cycle time, and hysteresis.
Configures communication protocol, speed, parity, stop bits, data length, address, and response time.
Sets retransmission output type, maximum, and minimum output values.
Configures alarm types, dead bands, set values, and pattern ending signals.
Sets fuzzy function, time unit, wait zones, wait time, and power recovery modes.
Configures PID parameters including Anti Reset Wind Up, Proportion, Integral, and Differential.
Sets up auto tuning type, operation, and stop conditions for PID optimization.
Details input types, ranges, resolution, resistance, and allowable signal source.
To Next Page
