16
GROUP SETTING
10
FunctionsExternal input signalDIS selection
Initial ValueDisplay conditionOperationNameSignal
Control group display
control mode selection
Zone selection
1
Fuzzy function selection
External contact input
selection
Set a control mode
LOCA / PROG / REM
OFF / ON
OFF / ON
( Refer to chart 1 )
OFF / 1 / 2 / 3
Always display
When local mode
selection
When P.I.D control
Always display
LOCA
OFF
OFF
OFF
OFF
1
2
3
SV 1 display and selection
SV 2 display and selection
Auto control
Manual control
Start (Program control)
Reset (Program control)
SV 1 display and selection
SV 2 display and selection
SV 3 display and selection
( When DI-1 and , DI-2 are ON, it is same )
Initial value is OFF (None)
DI-1
DI-2
DI-1
DI-1
DI-2
DI-1
DI-2
DI-1
DI-2
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
ON
OFF
( Chart1 )
Local, Program or Remote is selected in the control group mode using or key.
When selecting LOCAL mode, control zone selection and fuzzy function selection are available.
Control zone selection is not available when selecting program mode or remote mode.
Fuzzy function is operating in the P.I.D control. (not operating in the ON/OFF control)
Using two external contact input (DI) as ON/OFF, it is possible to control 3 kinds setting values
and Auto operation or Manual operation is selectable in the start, reset, local mode.
1 : This signal is not indicated in Program or Remote operation.
Zone P.I.D will be operated.
To Next Page
Loading...
Need help?
General
