11
Lowes.com/harborbreeze
FINAL ASSEMBLY INSTRUCTIONS
3. If you wish to use the light kit portion of the motor
assembly (A), install the bulb (D) and proceed to step
4. If you do not wish to use the light kit, skip to step 5
directly.
CAUTION: The bulb is pressurized and may shatter.
DO NOT TOUCH THE BULB WITH BARE HAND.
Fingerprints may result in shorter bulb life. Remove
fi ngerprints with alcohol prior to use. To reduce the risk of
fi re, use 75-watt max. type T4-minican JD E11 tungsten
halogen bulb. Turn off the wall switch and allow the bulb
to cool for 10 minutes before relamping.
D
3
4. Position the glass (B) onto the motor assembly (A)
and secure with the previously removed switch
housing screws (CC). Do not overtighten.
Assembly is now complete.
Hardware Used
CC
Switch Housing
Screw
x 4
A
B
CC
4
5. To use the fan without the light kit, position the steel
cap (C) onto the motor assembly (A) and secure with
the previously removed switch housing screws (CC).
Assembly is now complete.
Hardware Used
CC
Switch Housing
Screw
x 4
A
C
CC
5
To Next Page
Loading...
Need help?
General
