Harbor Breeze RLG52BNK5C3L User Manual (English)

Questions and Answers:

S
Sean Carter PhDAug 9, 2025
What to do if my Harbor Breeze Fan lights fail but the fan operates?
- P
  Peter SanchezAug 9, 2025
  If your Harbor Breeze Fan operates but the lights do not, there are several things to check. Begin by ensuring the bulbs are correctly installed. Then, inspect the wiring in the canopy to ensure it's properly connected. Also, verify that the wall switch to the light is turned on. Check the molex connections in the light kit fitter to ensure they are properly connected. Finally, make sure the light kit is lamped with bulbs totaling no more than 190W, as exceeding this limit can cause the wattage limiting device to interrupt power to the light kit.
H
Howard BanksAug 16, 2025
How to troubleshoot a Harbor Breeze RLG52BNK5C3L Fan that does not move?
- D
  Darius ClaytonAug 16, 2025
  If your Harbor Breeze Fan does not move, check the following: Ensure the reverse switch is fully engaged by pushing it firmly either up or down. Verify that the power is on or check the fuse. If the power is on and the fuse is good, turn the power off, loosen the canopy, and check all wire connections.
J
John MillerAug 25, 2025
Why is my Harbor Breeze RLG52BNK5C3L Fan wobbling excessively?
- J
  jamesvillegasAug 25, 2025
  Excessive wobbling in your Harbor Breeze Fan can occur due to several reasons: * Loose blades: Ensure all blade screws are tightened. * Incorrectly attached blade arms: Re-install the blade arms. * Unbalanced blades: Try switching one blade with a blade from the opposite side or use a balancing kit. * Insecure mounting: Turn the power off, carefully loosen the canopy, and verify that the mounting bracket is secure. * Proximity to vaulted ceiling: Use a longer downrod or move the fan to another location. * Loose set screws on the motor housing yoke: Tighten the yoke set screws securely. * Loose set screw on the hanging ball: Carefully loosen and lower the canopy, then verify that the set screw on the hanging ball is tightened securely.
C
Christina MccarthyAug 31, 2025
How to fix a noisy Harbor Breeze RLG52BNK5C3L Fan?
- M
  Matthew TuckerAug 31, 2025
  A noisy Harbor Breeze Fan can be caused by several factors. First, ensure all blade screws are tightened, as loose blades can cause noise. If a blade is cracked, it should be replaced. If you are using a full range dimmer switch, replace it with an approved speed control device. Also, new fans sometimes require a 'break in' period of a few days, especially when running the fan at medium and high speeds.

Harbor Breeze RLG52BNK5C3L Specifications

General

Brand	Harbor Breeze
Model	RLG52BNK5C3L
Type	Ceiling Fan
Blade Span	52 inches
Number of Blades	5
Motor Type	AC
Reversible	Yes
Remote Control Included	Yes
Light Kit Included	Yes
Finish	Brushed Nickel
Motor Speeds	3
Mounting Options	Downrod
Indoor/Outdoor	Indoor
Style	Contemporary
Finish Family	Nickel