11
HARDI
®
FOAM MARKER STANDARD VERSION
1. Locate and drill (2) 11/32” holes for tank mounting bracket by using the
measurements shown in (Fig. 6).
2. Position tank mounting bracket with bottom edge fl ush with the lower
edge of platform. Clamp into position and mark hole location for top
bolts using previously drilled holes in bracket as a template.
Drill (2) 11/32” holes.
3. Install and tighten all bolts.
6.1 HC 650M, 950, 950M, and Twin 650, 950
Fig. 6
6.0 MOUNTING THE TANK BRACKET
2’’ (50mm)
7-7/8“ (200mm) - 20 Gallon
5-1/2" (140mm) - 10/15 Gallon
To Next Page
Loading...
