Hardi NAVIGATOR 3000

6 - Maintenance
83
Greasing the Pump
The pump is greased as follows:
• Factory greased:
10 oz. (300 grams) grease into each lubrication point (A).
• Normal operation:
Grease every 50 hours with 1 oz. (30 grams) of grease into
each lubrication point (A). See “50 Hours Service - Greasing
the pump” on page 88.
• After disassembling the pump (diaphragm replacement, etc.):
Grease with 7 oz. (200 grams) of grease into each lubrication
point (A).

ATTENTION! In order to prevent excessive wear, it is important to
use a recommended lubricant! See “Recommended lubricants”
on page 81.

ATTENTION! The pump MUST be stopped during greasing!