26
INITIAL SETUP
HDMI Audio to TV: $ETERMINES WHETHER ($-) AUDIO SIGNALS
ARE PASSED THROUGH THE ($-) /UTPUT TO THE VIDEO DISPLAY )N NORMAL
operation, leave this setting OFF, as audio will be played through
the AVR. To use the TV by itself, without the home theater system,
TURN THIS SETTING /. -UTE THE 46S SPEAKERS WHEN USING THE !62 FOR
audio.
Semi-OSD Time Out: Program the amount of time
(2 to 5 seconds) the two-line semi-OSD status messages remain
on screen, or deactivate the semi-OSD display altogether if you find
it distracting. These messages will continue to appear on the front
panel of the receiver.
Full-OSD Time Out: Program the amount of time (20, 30,
40 or 50 seconds) the full-OSD menus remain visible on screen.
The full-OSD system may not be deactivated.
NOTE: It isn’t possible to view video sources while the full-
OSD menus are displayed.
Dim Function
4O DIM THE -ESSAGE $ISPLAY PRESS THE $IM "UTTON ON THE REMOTE
Each button press will cycle through the three settings of:
s 6&$ &ULL Normal brightness
s 6&$ (ALF Display is dimmed but still visible; the light inside
the volume knob goes dark
s 6&$ /FF Display goes completely dark except for Power
Indicator, to remind you that the receiver is turned on.
When you have finished, press the OSD Button to clear the menus
from view.
You are now ready to begin enjoying your new receiver!
To Next Page
Loading...
Need help?
General
