Need help?Do you have a question about the Harman Kardon AVR 500 and is the answer not in the manual?
Audio Specifications| continuous average power (FTC) | 80 Watts per channel, 20Hz–20kHz, @ < 0.07% THD, both channels driven into 8 ohms |
|---|---|
| power per individual channel (Front L&R channels) | 70 Watts per channel, @ < 0.07% THD, 20Hz–20kHz into 8 ohms |
| power per individual channel (Center channel) | 70 Watts, @ < 0.07% THD, 20Hz–20kHz into 8 ohms |
| power per individual channel (Surround channels) | 70 Watts per channel, @ < 0.07% THD, 20Hz–20kHz into 8 ohms |
| input sensitivity/impedance | 200mV/47 kohms |
| signal-to-noise ratio (IHF-A) | 95dB |
| frequency response | 10Hz–100kHz |
| high instantaneous current capability (HCC) | ±45 Amps |
| rise time | 16 µsec |
| slew rate | 40V/µsec |
FM Tuner Specifications| frequency range | 87.5–108MHz |
|---|---|
| usable sensitivity IHF | 1.3 µV/13.2dBf |
| signal-to-noise ratio mono/stereo | 70/68dB |
| distortion mono/stereo | 0.3/0.3% |
| stereo separation | 40dB @ 1kHz |
| selectivity | ±400kHz, 65dB |
| image rejection | 80dB |
| IF rejection | 90dB |
| tuner output level | 500mV @ 1kHz, ±75kHz Dev |
AM Tuner Specifications| frequency range | 520–1710kHz |
|---|---|
| signal-to-noise ratio | 45dB |
| usable sensitivity loop | 500µV |
| distortion | 0.8% @ 1kHz, 50% Mod |
| selectivity | ±10kHz, 30dB |
Video Specifications| video format | NTSC |
|---|---|
| input level/impedance | 1Vp-p/75 ohms |
| output level/impedance | 1Vp-p/75 ohms |
| video frequency response | 10Hz–8MHz (–3dB) |
General Specifications| power requirement | AC 120V/60Hz |
|---|---|
| power consumption | 78W idle, 694W maximum (2 channels driven) |
| width | 17.3 inches (440mm) |
| height | 6.5 inches (165mm) |
| depth | 17.1 inches (435mm) |
| weight | 34 lb (15.4 kg) |
Guides on connecting audio source equipment and speakers using high-quality cables and proper polarity.
Provides guidelines on selecting and positioning speakers for optimal soundstage and seamless front sound.
Details placement strategies for center, front-left/right, and surround speakers for the best listening experience.
Guides on setting speaker types (LARGE/SMALL) to ensure correct low-frequency signal distribution.
Details calibrating output levels using test tone or program material for accurate sound reproduction.
Explains how to adjust delay times for surround sound synchronization based on speaker distances.
Details how to select various surround sound modes (Dolby Digital, DTS, Logic 7, etc.) for different audio sources.
Explains digital audio advancements, Dolby Digital, DTS, and important notes on digital playback compatibility.
Explains the easiest method to program the remote by directly entering three-digit codes for various devices.
Describes how to program the remote using an auto-search function when codes are not listed or don't work.
Details how to reset the AVR 500's memory and microprocessor to resolve abnormal operation issues.
To Next Page
