Programming the Remote
To find out what function a particular
button has for a specific device, find
the button number on the Function List
and then look in the column for the
device you are controlling. For example,
button number 19 is the Test Tone button
for the AVR5, but it is the “Display” but-
ton for many TV sets. Button number 2
is the Preset Tune Down button for the
AVR5, and it is the “Reverse Skip” button
for DVD or LD players but has no function
for VCRs or TV sets.
NOTE: Only those buttons shown on the
diagram and table have functions with
products other than the AVR5. In addition,
some products may differ from the func-
tions shown in the table, and other buttons
may not function with some products.
Notes on Using the AVR5 Remote With
Other Devices.
• Manufacturers may use different code
sets for the same product category. For
that reason, it is important that you
check to see if the code set you have
entered operates as many controls as
possible. If it appears that only a few
functions operate, check to see if
another code set will work with more
buttons.
• When a button is pressed on the AVR5
remote, the LED Indicator å will
flash briefly. If it flashes for some, but
not all buttons for a particular prod-
uct, it does NOT indicate a problem
with the remote, but rather that no
function is programmed for the but-
ton being pushed.
28
To Next Page
Loading...
Need help?
General
