Harman Kardon DPR 1005 Front Panel Controls Guide

5
A
CB EF
HJ I
*
&
(
%
$
#
K
G
^
12 3 4
D
6
8
79)
!@
DPR 1005 FRONT-PANEL CONTROLS
The following controls and indicators are available on the DPR 1005’s front panel:
The following controls and jacks are located behind the front-panel door.To open the door, press the center of the door and gently swing it down towards you.
1 Standby/On Indicator
2 Standby/On Button
3 Surround Mode Group Selector
4 Surround Mode Selector
5 Tuning Selector
6 Tuner Band Selector
7 Preset Station Selector
8 Input Source Selector
9 Tuning Mode Selector
) Set Button
!
¤/⁄ Buttons
@ Front-Panel Control Door
# Volume Control
$ Input Indicators
% Speaker/Channel Input Indicators
^ Upper Display Line
& Lower Display Line
* Surround Mode Indicators
( Remote Sensor Window
A Main Power Switch
B Tone Mode Button
C Speaker Selector Button
D Channel Adjust Selector
E Digital Input Selector
F Delay Adjust Selector
G Headphone Jack
H Optical 3 Digital Input
I Input/Output Indicator
J Coaxial 3 Digital Input
K Video 5 Audio/Video Jacks
DPR1005WebDiagrams1 5/20/04 3:27 PM Page 1

Harman Kardon DPR 1005 Specifications

Audio Specifications

Continuous Average Power (FTC)	70 Watts per channel, 20Hz–20kHz, <0.15% THD, both channels driven into 8 ohms
Power per Individual Channel - Front L&R channels	70 Watts per channel, <0.15% THD, 20Hz–20kHz into 8 ohms
Power per Individual Channel - Center channel	70 Watts, <0.15% THD, 20Hz–20kHz into 8 ohms
Power per Individual Channel - Surround channels	70 Watts per channel, <0.15% THD, 20Hz–20kHz into 8 ohms
Input Sensitivity/Impedance	200mV/47k ohms
Signal-to-Noise Ratio (IHF-A)	97dB

FM Tuner Specifications

Frequency Range	87.5–108.0MHz
Usable Sensitivity IHF	1.3µV/13.2dBf
Signal-to-Noise Ratio Mono/Stereo	70/68dB
Distortion Mono/Stereo	0.2/0.3%
Stereo Separation	40dB @ 1kHz
Selectivity	±400kHz, 70dB

AM Tuner Specifications

Frequency Range	520–1720kHz
Signal-to-Noise Ratio	45dB
Usable Sensitivity Loop	500µV
Distortion	0.8% @ 1kHz, 50% Mod
Selectivity	±10kHz, 30dB

Video Specifications

Television Format	NTSC
Input Level/Impedance	1Vp-p/75 ohms
Output Level/Impedance	1Vp-p/75 ohms
Video Frequency Response (Composite and S-Video)	10Hz–8MHz (–3dB)
Video Frequency Response (Component Video)	10Hz–50MHz (–3dB)

General Specifications

Power Requirement	AC 120V/60Hz
Power Consumption - Standby	8.9W
Power Consumption - Idle	52W
Power Consumption - Max	760W (7 channels driven)

Weight and Dimensions

Width - Product	17.3 inches (440mm)
Width - Shipping	22.6 inches (573mm)
Height - Product	4.5 inches (114mm)
Height - Shipping	8.9 inches (225mm)
Depth - Product	18.8 inches (476mm)
Depth - Shipping	21.9 inches (555mm)
Weight - Product	23.1 lb (10.5kg)
Weight - Shipping	27.5 lb (12.5kg)