Harman PF100 - Operation - Starting the Furnace; Starting A Fire Automatically

24
3-90-08101R23_06/13
Starting A Fire Automatically
IMPORTANT: Be sure there is no fuel or other
combustibles in the ash pan prior to lighting.
1. Turn Mode Selector to “OFF”.
Thisresetsthecontrolinadditiontoturningitoff.
2. Fill hopperwithpellets.Whenllingthehoppercheck
forexcessivenesinthebottomofthehopper.Fines
aresmallpiecesofbrokenpellets(sawdust).Finesdo
notoweasilyandoftenbuilduponthehopperfunnel
bottomangles.Thesenescanbepushedintothe
feederopeningandthenllthehopperwithpellets.As
thesystemworks,theywillbeburned.
3. Clean burnpot withscraper,ifnecessary.Thisisusually
aweeklymaintenanceprocedure.Cleaningtheburnpot
withthescraperwithasmallamountofnewfuelinthe
bottomisnotaproblem.First,scrapetheashesonthe
frontoftheburnpotintotheashpan.Thenscrapethe
holegridsurfacedownwardintotheburnpot.Whenthe
stoveisignitedthesescrapingswillbepushedoutbythe
feeder.
Note: Ifthe DistributionBlower isrunningwhen theouter
doorisopen,someairwillescapearoundthedooropening.
Thisisnotaproblem.However,anydustthatiscausedin
thecleaningprocesscanpotentiallybetransferredthrough
theduct,orotherwisedispersed.
Operation
Fig. 47
Fig. 48
Fig. 46