Harman PF100 - Page 25

25
3-90-08101R23_06/13
4. If starting after an empty hopper, turn Feed Adjuster
to “TEST” (forone 60second cycle).

Thiswill charge
pelletsintotheaugertubeandalsoallowyoutocheck
themotorsforoperation.
NOTE: The auger motor will not operate with the furnace
door open.
5. Turn Feed Adjuster to #4. Ifthisisyourrstre,oryou
are trying different pellets, set thefeed adjuster to #4,
Fig.50.Thisisaconservativenumberandwillprobably
needtobeincreasedifmaximumBTUoutputisdesired.
Afteryouknowafeedratesettingthatworkswellforyour
application,usethatsetting.Remember,ifyourfeedrate
istoohighyoumaywastefuelduetoovershootingthe
WallControlsetting.
6. Flip the Igniter Switch up into the “AUTO-LIGHT”
position,Fig51.
7. Turn the Temperature Dial onthewallcontroltodesired
roomtemperature.Note:Thesettemperatureonthedial
mustbehigherthantheroomtemperatureforthereto
light,Fig52.
Operation
Fig. 49
Fig. 50
Fig. 51
Fig. 52
HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHING, AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS.
WARNING
!