| www.harmar.com | 800-833-0478
14
© 2018 Harmar Mobility, LLC • All Rights Reserved
Final Checks
Before putting the lift into operation for the user verify the following:
• Check all stops (top, middle & bottom)
• Foot rest (Both direction of travel)
• Rail obstruction-both directions
• Rail (all hardware and mounting hardware are tight)
• Final limit (both ends of travel)
• Seat swivel (lift won't run if seat is swiveled)
• Check all clearances to ensure there are no pinch points
• Provide the Owner’s Manual and review the lift’s operation and stops with the customer.
• Charge for 12 hours after testing is complete.
• Test wireless remote (in both direction of travel)
• Seat postion, level at top and bottom. If it is not level or customer would like the chair to have a slight
uphill tilt, adjust with the leveling joint.
- Loosen set screw (2.5 mm)
- Remove screw (6mm)
- Adjust joint in or out depending on which direction you want the chair to go
- Retighten all
The lift is now ready to use. Remember to leave the Owner’s Manual with the end-user and answer any
questions they may have on the use of the Curved Stair Lift.
FINAL CHECKS
To Next Page
