| www.harmar.com | 800-833-0478
4
© 2018 Harmar Mobility, LLC • All Rights Reserved
Drill
Assorted Drill Bits
Allen Wrenches
Emery/Sandpaper
Towels (for cleaning)
Lightweight grease (white lithium)
Tape Measure
Angle Meter
The tools required for installation of the lift will
be referenced throughout the manual. Each
page will have a tool icon area at the top to help
determine which tools will be needed during
that part of the installation.
REQUIRED TOOLS
Mirror for checking charger
Wire Stripper/Crimper
Fish Tape
Drill Extention Bit
Shims
Recommended: Volt OHM Meter
Optional: Pull Strap/Ratcheting Strap
Mounting Screws could be needed,
based on ooring (not shown)
To Next Page
Loading...
