To Next PageTo Next Page
Need help?Do you have a question about the Harmar Mobility Pinnacle Series and is the answer not in the manual?
General| Weight Capacity | 350 lbs |
|---|---|
| Seat Type | Padded |
| Battery Backup | Yes |
| Seat Dimensions | 18 x 16 inches |
| Footrest | Folding |
| Safety Belt | Yes |
Lists the basic tools suggested for installation of the stair lift.
Instructs to inspect and check the contents of included parts before installation.
Details how to measure and determine the correct rail length for stair lift installation.
Step-by-step guide for assembling and installing the stair lift rail onto the stairs.
Instructions on positioning and tightening rail brackets on the stairs for secure mounting.
Guide on how to safely slide and secure the chassis onto the installed stair lift rail.
Steps for installing the top limit cam, charging strips, and end plate for the rail.
Instructions on installing rack pre-compression screws and connecting the power supply.
Detailed steps for installing the footrest and seat onto the stair lift chassis.
Connecting seat and footrest cables, and instructions for switching armrest controls.
Step-by-step guide to relocate the armrest control from the right to the left side.
How to operate the stair lift using the remote call/send controls.
Procedure to re-program the remote call/send controls if needed.
Verifies the correct operation of the armrest control switches for lift movement.
Instructions for fully tightening the rail bracket mounting screws for structural integrity.
How to set the upper and lower travel limits for the stair lift's safe operation.
Procedures to test all safety stop switches for proper function and obstruction detection.
Further testing of safety stop switches and handling of potential failures.
Performing final system checks, including deceleration, compression screw adjustment, and seat swivel.
Steps to orient and attach rail brackets to the folding rail.
How to place the rail on the stairway and check clearance requirements.
Fastening rail brackets, joining upper rail, and adjusting feet height.
Reinstalling caps, checking fork operation, and testing the folding rail.
