VPL400-X: Owner’s Manual
05MAY23 | 610-00103 A
11
OPERATION
HIGHLANDER 400-X: SECTION 3
6. If you have a " drive ratchet or a cordless
drill with a " socket adapter bit and a "
socket or " hex bit extension (not included),
power the drill in the forward direction -
rotating clockwise to lower the platform.
Do not drive it with an impact or hammer drill.
NOTICE
NOTE: The drive motor is equipped with a low holding
force brake to prevent the platform from drifting with
heavy loads. Lowering the platform with this brake on will
require a bit of strength, typically the equivalent of being
able to lift 20 lb with one arm.
7. Rotate the motor shaft clockwise to lower
the platform.
NOTE: Do not attempt to raise the platform. The required
torque to do so is substantially higher.
8. Stop rotation when the platform is level with
the lower landing.
9. Return the Brake Release switch to the down
position to re-engage the brake.
10. If the platform gate doesn’t open, use the
interlock key to open the gate from the
outside.
Wait for a Harmar dealer to service and inspect
the li prior to using it again.
WARNING
!
To Next Page
Loading...
