5.3 Safety information – maintenance and inspection
Only allow maintenance and inspection work to be carried out by or under the supervision and
guidance of trained expert personnel who, on the basis of their specialist training, knowledge
and experience - in addition to knowledge of all the relevant regulations - are capable of
evaluating the condition of the bed and of recognising any possible effects and hazards.
Always read the relevant chapters of this User Manual thoroughly before carrying out
maintenance and inspection work.
Any damage resulting from non-observance of this User Manual is excluded from any liability
of the manufacturer.
Caution
•
Always carry out a function test following maintenance work and inspections.
•
When operating the actuator motors, ensure that the bed cabling cannot be pinched,
overstretched or kinked.
Caution: Hazards due to electrical and mechanical faults!
•
Immediately remove faulty/defective beds from operation and secure them against
unauthori]ed use. Disconnect the mains plug from the wall socket.
•
Only use original spare parts from
Harmony
3URGXFWV.
•
Always carry out the prescribed maintenance and inspection work at the specified
intervals,see Section 16 Maintenance and Inspection.
•
Do not carry out any alterations to the electricalor mechanical fittings supplied withthe
bed unless authori]ed to do so by the manufacturer. Unauthori]ed alterations leadto
any liability of the manufacturer becoming nulland void.
•
Only perform maintenance and inspection work usingsuitable tools.
•
Do not open electrical components.
6.
Environmental Conditions
Min Max
10Operating temperature range
0
40C
0
C
60%10%Relative Humidity (RH)
3,000m0mAltitude range (above mean sea level)
The IP (liquid and dust ingress) rating for the control module on
the
+RPH CDUH
Bed
isIPX6.
The
Home Care Bed
are designed for medical purposes only.
Electricalinstallationsmust
comply with your local electrical installation requirements.
Page 10 of 2
8
To Next Page
Loading...
