Duration of High temperature disinfection
Hour timer of disinfection (hour setting)
Minute timer of disinfection
Start of large amount water usage time
End of large amount water usage time
Starting 1st Running period
Starting 2nd Running period
Starting 3rd Running period
Target temperature of 1st Running period
Target temperature of 2nd Running period
Target temperature of 3rd Running period
L17
Target temperature of compressor and electrical
heater (Immersion) during disinfection
60-63
60
Unit status table
Unit Status Code Definition Display Range Display Value Comments
A0 Cylinder temperature
(Parameter F3=0）
Indoor Ambient Temperature
A5 Water Outlet Temperature -31
~99
（Parameter F3=0） Measured Value
pump is
connected
A9 Expansion Valve Steps 6~50 Measured Value
value*10
15 Inspection and Maintenance
The Thermopod should be cleaned with water only and if necessary non-abrasive detergent.
Note: When cleaning, please make sure that the main electrical supply is turned off and do not clean the panel if in
the direct sunlight.
The system should be drained off if the Thermopod is out of usage for a prolonged time period and the electrical
supply to the Thermopod should be isolated
16 Relocation after first Installation
Sometimes the user may want to relocate their Thermopod after first installation. It is important to keep all refrigerant
inside the system before relocation. Here below are the steps,
Thermopod - Installation Manual 24 | Page
To Next Page
Loading...