12
English
GB
Instructions for the metrological check
Every Veroval
®
monitor has been carefully tested by HARTMANN for measure-
ment accuracy and has been developed with a view to a long service life. We
recommend carrying out a metrological check every 2 years for devices in pro-
fessional use, for example, in pharmacies, medical practices or hospitals. Please
also observe the national regulations specified by the legislator. Metrological
checks may only be carried out by the competent authorities or authorised main-
tenance providers against cost reimbursement.
Instructions for calibration mode
A functional check of the monitor can be carried out on people or using a suit-
able simulator. A metrological check involves testing for leaks in the pressure
system and possible deviations in the pressure reading. Remove at least one
battery to switch to calibration mode. Now hold the START/STOP button down
and re-insert the battery. Release the button after a few seconds and, after a
few moments, ’
’ will appear on the display. ’ ’ and ’ ’ will then appear.
Press the START/STOP button briefly. ’ ’ and ’ ’ will appear on the display.
Instructions on the metrological check will be supplied by HARTMANN upon
request to the competent authorities or authorised maintenance providers.
Disposal information
To protect our environment, empty batteries must not be disposed of in house-
hold waste. Please comply with the relevant waste disposal regulations or use
public collection points.
This product is subject to the European Directive 2012/19/EU on Used
Electrical and Electronic Equipment and is marked accordingly. Never
dispose of electronic equipment in your household waste. Please obtain
information about local regulations on the proper disposal of electrical
and electronic products. Proper disposal protects the environment and
human health.
3. Blood pressure information
To determine your blood pressure you need to measure two values:
SYS – Systolic (upper) blood pressure, which is produced when the heart con-
tracts and pumps blood into the blood vessels.
DIA – Diastolic (lower) blood pressure, which is the value measured when the
heart muscle is dilated and fills again with blood.
Blood pressure values are displayed in mmHg.
To Next Page
Loading...
Need help?
General
