X1D www.hasselblad.com
USER GUIDE
109
Settings
Control Screen
Screen after a capture
Live View
Remaining number
of frames.
Time in seconds
until next exposure.
Interval Timer
active.
ISO
f/
400
143
EV
10.0 12 20
4 60
1
2
0.0
ISO
f/
400
143
EV
10.0 12 20
4 60
1
2
0.0
An active and pending Interval Timer, is
indicated both on the Control Screen and
in Live View.
In the example to the right, a total of 20
images will be captured with an interval
time of 12 seconds.
4
Exit
INTERVAL TIMER
20
18-03-03 15:04:32B9997904
f/5.6 125 0.0EVISO 100
1
2
19
After a capture, the image will show up
on the rear screen, together with the
Interval information.
To end the sequence before all captures
have been made, press Exit (the Star
Button).
Note!
Live View is turned off during an Interval
sequence.
Note!
The preview can be turned off in the
"General Settings - Display - Image
Preview - Rear Screen" setting.
Note!
Interval is not supported in Phocus
Mobile or when tethered to Phocus. For
tethered operation, use the Capture
Sequencer function in Phocus.
Note!
During a running Interval Sequence, you
can press the Menu Button to activate
the Control Screen to check current
status.
To start the sequence, simply press
the shutter release. If you have set an
initial delay to prevent camera shake, the
camera will rst wait the pre-set number
of seconds with a black screen (A), and
then start the Interval sequence.
A
Table of Content
To Next Page
Loading...
