RECHARGEABLE BATTERY SPECIFICATION
LI-ION/ BATTERY CHARGER 3053573 BCX-1
– PRECAUTIONS and GENERAL
The battery should be charged for approximately 6 hours before
rst time use.
The battery must be charged at room temperature.
Maximum battery capacity is reached only after the battery has
been charged and discharged several times.
Avoid frequent full discharges (a full discharge is signalled by
the appearance of the Replace battery warning). As the battery
is a Li-ion type, it has no ‘memory effect’ of practical importance
and therefore frequent recharges will cause no problems
such as loss of capacity or poor performance. It is therefore
better policy to recharge the battery at very regular intervals,
regardless of use.
Remove the battery if you intend to store the camera for some
while as it will eventually become completely drained, even
though the camera is turned off. Mount the Battery Protection
Cover when storing the Battery.
The battery has an integrated ‘fuel gauge’ capability that
supports the Replace battery and Battery status functions. As
with most Li-ion batteries, this capability should be occasionally
calibrated, depending on how much the battery is used. To do
this, leave the camera on (or use it), until the Replace battery
warning appears. Then, recharge the battery for 6 hours. This
will improve the accuracy of the measurements.
When removing a battery from the charger and immediately
replacing it with another, allow a few seconds to elapse so
that the charger can automatically reset for the next charging
procedure.
It is perfectly normal for the battery to become warm when being
charged.
A slight temporary loss of battery performance might be noticed
at very high or low temperatures. Take the appropriate measures
if this is the case.
If you do not intend to use the battery for a while, it is best to
store it at room temperature with an approximate 30 to 40%
charge. You can check the percentage level on the status
screen.
The battery should have a usable service life of around 400
recharge/discharge cycles.
Connect the battery to the camera correctly.
Keep the Battery Protection Cover in place when not in use.
(Short circuiting across keys in a pocket, for example, could
cause a risk of re).
Do not immerse the battery in liquids.
Do not incinerate the battery.
Please recycle or discard in an environmentally approved
manner.
Use indoors only (protect against moisture).
Do not short circuit the jack plug.
Do not alter the charger in any way other than changing the plug
attachment.
Note!
You can save battery consumption by changing the Display Off
/ Power Off settings as well as the Brightness settings of the
display.
X1D www.hasselblad.com
USER GUIDE
89
Functions
Table of Content
To Next Page
Loading...
Need help?
General
Weight and Dimensions
