haTmed Q50B - Helix Test; Drainage Program; System Settings; Time Setting

- 21 -
5.3 HelixTest
TheHelixtestisusedtoverifythesteampenetrationandsaturationforAtypehollowinstruments,suchas
dentalhandpieces.SelecttheHelixtestinthetestprograminterface(Figure5.1).

 Testmethodsandtestresultsarejudgedinaccordancewiththe
information and requirements provided by the test package
manufacturer.

5.4 Drainageprogram
Thisproductallowsuserstoperformdrainageprocedureswhenneeded.Thisprocedureisusedtodrainwater
remaininginasmallsteamsterilizer.

 Whenthewaterinthechamberisobviousafteropeningthedoor,
itisrecommendedtousethedrainageprogrambeforeloadingthe
itemforsterilization.Especiallywhentheprogramisabnormally
stopped,thissituationiseasytooccur.Pleaseopenthedoorfor
inspection.
 Please carry out the drainage program before handling this
product.
6 Systemsetting
Enter the system settings interface (Figure 6.1) for time, date, language, warm‐up, automatic printing,
additionaldryingsettings,andsystemreset.






Fig6.1Systemsetting

6.1 Timesetting
Thetimesettingoperationisasfollows:





 


1–Sterilizationprogram
2–Testprogram
3–Systemsetting
4–Filerecord
Press to enter
systemsetting
Timesetting
Datesetting
Languagesetting
Warm‐upsetting
Press to enter
timesetting
press and tosetup
time.Press toswitchbetween
time,minute and second.After
setting press to exit time
setting.

Timesetting

10：27：39