BCS 6000C
BURNER CONTROL SYSTEM
Table of Contents
Subject
Page
A. General Information ………………………………………………………….. 2
B. Receiving and Inspection…………………………………………………….. 3
C. Installation……………………………………………………………………... 3
D. Adjustments and Final Checkout…………………………….……………… 5
E. Electronic Valve Characterization…………………………………………… 9
F. Operation……………………………………………………….……………… 11
G. Troubleshooting……………………………………………………………….. 13
Appendix A: Operator Interface Screens………………………………….. 16
Appendix B: Configuration Record………………………….……………… 20
Appendix C: Recommended Spare Parts…………………………………. 21
Appendix D: DL250 Programmable Controller…………….……………… 22
Appendix E: High Temperature Limit………………………………………. 24
Appendix F: Exhaust Fan Flow Limit Installation…………………………. 27
Appendix G: Stack Thermocouple Installation……………………………. 28
Appendix H: Material Thermocouple Installation…………………………. 29
Appendix I: Draft Transmitter Adjustments……………….……………… 31
Appendix J: Flame Supervision and Safety Component Check List…... 33
Appendix K: Auxiliary Analog Input ….................................................... 38
Appendix L: Optimizer Operation ….................................................... 39
Attachments: Applicable Hauck Drawings
INSTRUCTIONS
WARNING
These instructions are intended for use only by experienced, qualified
combustion start-up personnel. Adjustment of this equipment and its
components, by unqualified personnel, can result in fire, explosion, severe
personal injury, or even death.
HAUCK MANUFACTURING CO., 100 North Harris Street Cleona, PA 17042 717-272-3051
3/14 www.hauckburner.com Fax: 717-273-9882
BCS-6000C-9
These instructions are intended to serve as guidelines covering the installation, operation, and maintenance of Hauck equipment. While
every attempt has been made to ensure completeness, unforeseen or unspecified applications, details, and variations may preclude
covering every possible contingency. WARNING: TO PREVENT THE POSSIBILITY OF SERIOUS BODILY INJURY, DO NOT USE OR
OPERATE ANY EQUIPMENT OR COMPONENT WITH ANY PARTS REMOVED OR ANY PARTS NOT APPROVED BY THE
MANUFACTURER. Should further information be required or desired or should particular problems arise which are not covered
sufficiently for the purchaser's purpose, contact Hauck Mfg. Co.
To Next Page
Need help?
General
