Haussmann RL User Manual

1-24 InstallatIon
P/N 0387183_V
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
INSTALLING SPLASHGUARDS AND BRACKETS
(RLTM Cases)
To install splashguards and brackets:
1. Slide the splashguard support bracket’s small
flange into base rail slots. Next, slide the splashguard
retainer assembly under the case as shown.
2. Rotate the retainer assembly clockwise (from right
hand side) while pulling towards the front of the case,
until the forward most flange sits flush with the back
of the color panel.
3. Align the retainer assembly with and attach to the
support bracket using #10 screws. Then install a #8
screw through the color panel into the top retainer
flange.
DO NOT
place shims under splashguard brackeTs.
Splashguards Installation
Splashguard
Splice Connector
Side
Detail
R L NS 5 A
1. S lide the splashg uard s uppor t bracket's small flange into the
slots in the bas e rail. Then s lide the splas hguard retainer
ass embly under the cas e as shown.
2. R otate the retainer as s embly clockwise (from right hand side)
while pulling towards the front of the case until the forward
most flange sits flus h with the back of the color panel.
3. Align the retainer as sembly with and attach to the s upport
bracket us ing #10 s crews. T hen install a #8 s crew through the
color panel int
o the top retainer flange.
R L NS 5 A
1. S lide the splashguard s upport bracket's small flange into the
slots in the base rail. T hen s lide the s plashguard retainer
ass embly under the case as shown.
2. R otate the retainer as sembly clockwise (from right hand side)
while pulling towards the front of the case until the forward
most flange sits flush with the back of the color panel.
3. Align th e retainer as sembly with and attach to the support
bracket us ing #10 screws. T hen install a #8 screw through the
color panel int
o the top retainer flan ge.
R L NS 5 A
1. S lide the splas hguard support bracket's small flange into the
slots in the base rail. T hen s lide the s plas hguard retainer
assembly under the cas e as s hown.
2. R otate the retainer as s embly c lockwise (from right hand s ide)
while pulling towards the front of the cas e until the forward
most flange sits flus h with the back of the color panel.
3. Align the retainer as sembly with and attach to the s upport
bracket using #10 s crews. Then ins tall a #8 screw through the
color panel int
o the top retainer flange.
1.
2.
3.
Permit Number:
20-05195

Haussmann RL Specifications

General

Brand	Haussmann
Model	RL
Category	Merchandiser
Language	English