5-2 Maintenance
P/N 0387183_V U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
do use:
• Remove the product and all loose debris to avoid
clogging the waste outlet.
• Store product in a refrigerated area such as a
freezer. Remove only as much product as can be
taken to the freezer in a timely manner.
• First turn off refrigeration, then disconnect
electrical power.
• Thoroughly clean all surfaces with soap and hot
water. Do not use steam or high water
pressure hoses to wash the interior.
these will destroy the merchaNdisers’ sealiNg
causiNg leaks aNd poor performaNce.
• Remove screws and lift hinged fan plenum for
cleaning. be sure to repositioN the faN pleNum
after cleaNiNg merchaNdiser.
• Take care to minimize direct contact between fan
motors and cleaning or rinse water.
• Rinse with hot water, but do NOT flood. never
introDuce water faster than the
waste outlet can remove it.
• Allow merchandisers to dry before resuming
operation.
• After cleaning is completed, turn on power and
refrigerant to the merchandiser.
• Verify that merchandiser is working properly.
CLEANING HONEYCOMB
ASSEMBLIES
Honeycombs should be cleaned every six months.
Dirty honeycombs will cause merchandisers to
perform poorly. The honeycombs may be cleaned
with a vacuum cleaner. Soap and water may be used
if all water is removed from the honeycomb cells
before reassembling. Be careful not to damage the
honeycombs.
1. Remove the sheet metal screws located in the
front metal retainer which holds the honey comb
assembly in place.
2. Lift the honeycomb assembly out of the L-bracket
to remove it.
3. Clean and dry the honeycomb.
4. After cleaning, reassemble in reverse order of
removal.
Product will be degraded and may spoil if
allowed to sit in a non-refrigerated area.
To Next Page
Loading...
Need help?
General