Hayter 455E - Adjusting the Blade Brake Cable

halvestogether.Mountthescrewsorboltsinthe
opposingholes(Figure31).
5.Checkthealignmentofallpartsandtightenthe
screws,alternatingfromsidetosideforauniformt,
untilthewheelhalvesaredrawntogether(Figure31).
6.Installthe2boltsand2locknutspreviouslyremoved
intheremainingholesinthewheelhalvesand
tighten.Removethe2longscrewsorboltsand
replacethemwith2boltsand2locknuts(Figure31).
7.Installthewheeltothepivotarmwiththebolts,
aspacer,andalocknut.Ensurethatthespaceris
positionedbetweenthewheelhubandthepivotarm
(Figure31).
ControlsSystem
Maintenance
AdjustingtheBladeBrake
Cable
Wheneveryouinstallanewbladebrakecableassembly
orreplacethebelt,adjustthebladebrakecable.
1.Stoptheengineandwaitforallmovingpartstostop.
2.Disconnectthewirefromthesparkplug(Figure12).
3.Removethefueltankfromthetankbracket.
Note:Youdonotneedtodisconnectthefuelline
fromthefueltank.
4.Resetthecableadjusteronthehandlesothat1/4
inch(6mm)ofthethreadsshow,thentightenthe
nut(Figure32).
Figure32
1.Adjuster
3.1/4inch(6mm)ofthreads
2.Nut
5.Loosenthecableclampscrewuntilthebrakecable
conduitslides(Figure33).
23