HBM U93 - 1 Scope of Supply; 2 Application Instructions

U93
8
A2081-2.2 en/de/frHBM
1 Scope of supply
• U93 force transducer
• U93 operating manual
• Manufacturing certificate
2 Application instructions
The U93 type series transducers are suitable for measuring tensile and com
pressive forces. Because they provide highly accurate static and dynamic
force measurements, they must be handled very carefully. Particular care
must be taken when transporting and installing the devices. Dropping or
knocking the transducers may cause permanent damage.
It is essential to provide careful sealing so that the sensitive strain gage ap
plications are protected by the housing. Particular caution must be exercised
with the base of the housing, which is very thin.
The specifications on page 20 list the permissible limits for mechanical, ther
mal and electrical stress. It is essential that these are taken into account when
planning the measuring set‐up, during installation and, ultimately, during op
eration.