headway EDB-2 VAP - Earth Protection and Mains Safety

1.1.2 EARTH PROTECTION & GROUNDING - To prevent electric
shock, ensure that any Input/Output cables from EDB-2 VAP
are connected to amplification or signal processing devices
(e.g. mixers ) with a continuous, unbroken chain of mains earth
connection. Try to ensure that the mains supply at the venue
offers a viable earth / ground connection. DO NOT disconnect
any ground / earth wire on a mains powered device, mains
distributor/extension lead, or wall socket
1.1.3 MAINS PROTECTION - Always take care to protect your
own life and those of others along with your equipment by
using RCD circuit breakers and AC mains surge protectors at
each source of the mains power. Circuit breakers should be
tested prior to use. Headway recommends the use of mains
noise filters
Switch Off D.C Power Supply Unit and other connected mains
powered devices and unplug when EDB-2 VAP is not in use
1.1.4 PREVENTION OF SHOCKS & DAMAGE - Do Not expose
the EDB-2 VAP, its Power Supply Unit or attached devices to
any liquids, such as rain/spilt drinks. If your EDB-2 VAP should
come in contact with any liquids, switch off at mains power
socket, disconnect and dry EDB-2 VAP and hands before reuse
SHOCKS WARNING - Switch off any sound equipment
immediately, when even minor electric shocks are detected
and seek a practical consultation from a qualified professional
electronics repair technician. The use of radio microphones
and their transmitters will limit the likelihood of shocks. Use
government type approved radio microphones on their
allocated frequencies
P. 18