Dimensions of retail packaging complete with
EDB-2 VAP = 268mm x 235mm x 105mm (10.55" x 9.25" x 4.13")
Microphone stand bracket connector: Female threaded bush on rear
at 9/16” to 19/32" (15mm approx.). DO NOT OVER TIGHTEN!
19.2 ELECTRICAL SPECIFICATIONS
19.2.1 CH.1 & CH.2 jack input impedance
Located on top - 3 way switch
Low impedance/active = 1.2 Meg. Ohm
High impedance = 6.8 Meg. Ohms
High+ impedance = 20 Meg Ohms
Gain Control to Ch.1 jack: Continuously variable 0 - +32dB jack IN:
Offers mono signal path IN via tip plus Phantom Power 10v option,
sent when switched on via ring or tip switching options
Gain Control to Ch.2 jack: Continuously variable 0 - +32dB jack IN:
Offers mono to ring (Ch.2) or Stereo signal path IN via jack: Tip to
Ch.2 & ring to Ch.1
XLR Microphone Inputs on Channels 1 and 2: Continuously variable
0 - +50dB and switchable Phantom Power 10v -48v option.
XLR Microphone Inputs: Impedance = 3.4kOhm
19.2.2 BAXENDALL INTERACTIVE 5 BAND EQ SECTION
Treble: @ 10.5 kHz +/- 12dB Shelf
Presence: @ 2.8 kHz +/- 7dB
Upper Mid: @ 880 Hz +/- 12dB
P. 76
To Next Page
Loading...