headway EDB-2 VAP - Range Control Specifications; Phantom Power Specifications

Low Mid: @ 590Hz +/- 13dB
Bass: measured @ 120 Hz +/- 12dB Shelf.
Bass if measured @ 45Hz +/- 16dB Shelf
Enhancer > 1khz / +2dB in max right position (CW)
Enhancer 10kHz / +2.3dB in left (ACW) position of control (CW) to
+10dB in max right position (ACW)
19.2.3 RANGE - Rotary pots controls x2 set a high pass filter which
rolls off lower frequencies from an increasingly higher frequency
point as turned CW (See 11.0 RANGE CONTROLS /
ANTIFEEDBACK Ch.1 & Ch.2)
19.2.4 Phantom Powering of all present and earlier models of
EDB. Output XLR does NOT accept 48v phantom from a mixer, as
milliamps power provided is not sufficient to power EDB
pre-amplifiers' high performance, multi-function features. If phantom
was applied to XLR outputs from a mixer, there would be no
damage.
19.2.5 PHANTOM POWER TO IN JACK - SWITCHABLE
In jack socket: 10v or 5v with 10mA Current Limit on ring option, for
tip setting. 3 Way Switch: Off / Ring / Tip
19.2.6 CURRENT DRAW
Minimum = 360mA
+ additional draw if Notch Filter On = 0.2mA
+ additional draw if Phantom Power On = 0.1mA
Maximum total draw = 323mA with red Mute L.E.D on
+ additional Headway HE5 pickup + phantom 10v = 4300uA
P. 77