headway EDB-2 VAP - Output Specifications

+ additional Proel mic CM 602 + phantom 10v = 0.6mA
+ additional Proel mic CM 602 + phantom 48v = 20mA
246mA in standby mode
+ additional (21mA) draw from whatever microphone or other device
is accepting phantom power from EDB-2 VAP short circuit current
on phantom 48v - 46mA (current limit resistors 6k8 on XLR+ pin/
-pin)
+ additional 240mA current maximum current consumption from 18v
power USB Charging Port : USB 2.0 type A. 5v DC Output
Maximum Current Load = 0.5A (with over current protection)
Includes Logic on board ~ does not allow use of charging function
via batteries
Charger is available when EDB-2 VAP is ON or at Standby
19.2.7 OUTPUT - Line Output via jack: Nominal v RMS @ 150
Ohms Mix of Ch.1 & Ch.2 + Aux In via mono jack socket.
(Standard ." / 6.35mm Diam.)
D.I Balanced Output via XLR Adapter: Nominal v RMS @ 150
Ohms electronically balanced (mono)
XLR IN/Out wiring is standard: Pin 1 = Earth/Ground, Pin 2 =
+Signal (Plus), Pin 3 = - Signal (negative)
Noise level (True RMS 20 Hz-20 kHz) At/@ 20 dB gain, EDB-2 VAP
produces - dBu. At /@10 dB gain, EDB-2 H.E produces - dB
distortion: THD
See: Noise notes 6.1
P. 78