Allows control of treble at higher end of the audio spectrum which
offers increased brightness on turning CW, or a “mellow” sound on
ACW
Treble overlaps mainly into Presence area. However, low strings will
also produce some high tones or harmonics if they are not old and
corroded
Cut Treble ACW to reduce high end feedback, harshness, externally
generated hiss, squeaks from new strings or to compensate for
over-bright pickups or hard reflective rooms
Increase Treble CW to compensate for old, dull strings, weak top
strings, mellow pickups or dull, boxy rooms and P.As
Use Treble control to fine tune the effect of the Harmonic Enhancer
control. For bright sounding piezos, try applying a treble cut, while
the Harmonic Enhancer control is placed about halfway up CW or
full ON to the right
Humbucker magnetic pickups and flexible piezo film contact pickups
will almost certainly benefit from treble control increases in addition
to turning Harmonic Enhancer CW
6.3.5 PRE-POST EQ SWITCH TO D.I XLR OUTPUTS
Located on top
To apply EQ to signals or remove EQ from either channel instantly
without needing to change EQ settings, or to apply Pre EQ to XLR
(B), with Post EQ to XLR (A) Output. Post-EQ describes EQ within
the setting. Pre-EQ removes EQ from the setting. The three main
applications are:
P. 41
To Next Page
Loading...