Heathkit SB-1000 - Unpacking Instructions

Heathkit
Page 7
UNPACKING INSTRUCTIONS
Do not unpack any part of your kit until a step
directs you to do so.
Locate the "Pack Index Sheet” that is packed inside
the main shipping carton for your Linear Amplifier.
Note that the shipping carton is divided into six
smaller sections. These sections make up Packs 1
through 5-- and the Final Pack, which may be made
up of several bags, envelopes, small boxes, and loose
parts. Do not unpack any of these parts until a step
specifically directs you to do so.
When you check parts against a "Parts List,” return
any part or group of parts packaged in a bag or other
container, with a part number on it, to its container
after you identify it. Leave these parts there until
you actually use them in a step. This will help
prevent you from mixing up the parts, and help you
identify the parts when you need them.
Some parts, however, are in a bag or envelope that is
not marked with an actual part number, but with a
packaging number that begins with the number
"173-.". These numbers are used for packaging
purposes only and do not appear in the Manual parts
lists. Open each bag or envelope that is marked
with only a "173-" packaging number to identify the
parts it contains.
NOTE: Never use a "173-" packaging number if you
must order a replacement part. Use only the part
numbers listed in a Manual parts list for this
purpose.
Save all of the packaging material until you account
for all of the parts.