Heathkit SB-104 - Page 144

Power Amplifier Circuit Board
TROUBLESHOOTING CHART
Refer to the "Voltage Chart" and "X-Ray View" (fold-out
from this page).
SYMPTOM
No RF output.
NOTE: Heath part numbers that correspond to the circuit
component numbers will
be found in the Parts List starting
on Page
151 of this Manual.
POSSIBLE CAUSE
1. Transistors. See "P.A. Transistor
Check" on the fold-out.
2. Inductors (coils) connected wrong.
3. No 13.8V at plns 5 and 6.
4. No .7V at pin 1.
5. Pins 2 and 4 not grounded.