Heathkit SB-104 - Page 27

REW
BOTTOM
$ #. LOCKWkStIER
6-32 NUT
PICTORIAL 12-40
1
Refer to Pictorial 12-41 for the next four steps.
(
) Attach a cabinet retainer strip to each side panel. Use
NOTE: The top and bottom cabinet shells are identical
a 10-32 x 112 screw and two 3M" OD flat washers at
except that four holes are provided in the bottom shell for
holes GC and GK on the right side panel and holes GM
attaching the feet. If you wish your Transceiver to have an
and GP on the leh panel. Leave the screws loose.
upward tilt of the panel, use both the tapered spacers and
the rubber feet at the hyo front Corners of the bottom shell.
( ) Place the chassis in the cabinet bottom shel 1 with the
cabinet edge between the retainer strip and the 314"
Refer to Pictorial 12-40 for the next two steps.
flat washers. The bodies of the 10-32 screws must rest
in the half-circle cutouts in the cabinet edge.
I ) If you wish to have the Transceiver cabinet sit twel,
install a rubhr foot at each corner of the bottom
( ) Similarly, place the top cabinet shell on the chassis
cabinet shell. Use 6-32 x 112" hardware.
with its
lower edges between the retainer strip and the
flat washers. Turn the bard pullers down.
, ( ) If you wish the front panel tilted upward, install a ( ) Tighten the four 10-32 scrms.
rubber foot on each rear corner with 6-32 x 112''
hardware. Install a tapered spacer and a rubber foot at
This completes the assembly of your Transceiver. Proceed to.
each front corner with 6-32 x 1-1 12" hardware.
the "installation" section.