Heatmiser JG PRT-E - Setting the Mode

Setting The Mode
The PRT-E has 4 modes, these are explained below:
Mode No. Mode explanation
00 Non programmable mode with built in air sensor
01 Non programmable with remote sensor options
02 Programmable mode with built in air sensor
03 Programmable mode with remote sensor options
First select the best mode which suits your application, and
then follow the steps below to setup the thermostat:
1. Turn off the thermostat by pressing and holding the Power
button.
2. Press and hold the H key for 10 seconds.
3. Using the Up/Down keys, you should select the mode
required.
4. Press A to accept.
13