5
Installation Procedure
Do’s
1. Do mount the thermostat at eye level.
2. Do read the instructions fully so that you can get the best
from our product.
Don’ts
1. Do not install near a direct heat source as this will affect the
workings of the thermostat.
2. Do not push hard on the LCD otherwise you will damage the
liquid crystal display and this is not repairable.
Installation
The thermostat is designed to be ush mount, a back box of
35mm should have been sunk in the wall prior to installation.
Step 1
Carefully separate the front half of the thermostat from the
back plate by placing a small at head terminal driver in to the
slots on the bottom face of the thermostat.
To Next Page
Loading...
