73
The water in the HEATMOR™ should be chemically analyzed once per year to ensure
the proper levels of treatment are being maintained. Contact your local dealer as to where
to have your water tested. Provide the testing person with an amount of water from your
HEATMOR™, equal to approximately 20 ounces, in a clean container. The amount of
water treatment that has to be added yearly is dependent on how much fresh water you
have added to your system since the last test. Be certain to add a water treatment that is
approved by your dealer and HEATMOR™ Inc.
NOTE: To keep the Control (water chemical) circulated and properly coated throughout the
HEATMOR™ system, it is recommended to start pumps at least once a month for approxi-
mately 2 - 3 hours.
CAUTION: It is recommended to start your pumps AFTER you bring your furnace up to
temperature. This helps ensure your system isn’t air locked and ensure your water is circu-
lating correctly.
To Next Page
Loading...
