82
PROBLEM CAUSE SOLUTION PROCEDURE
Somewhere in the domes-
tic water system of the
house, the hot and the cold
can mix (as in a single fau-
cet outlet) and the resulting
mixed warm water is being
sent to the hot water taps
instead of pure hot water
Contact your Local Dealer
Manifold not balanced
properly. Once appliance
getting more than its
share of the total ow of
hot water
Balance the system by
adjusting the ow of water
to the different heating
appliances.
Refer to “Installation
Manual”
Outdoor furnace water
temperature is not con-
sistently within operating
range.
Refer to “Installation
Manual”
Over time, (approx. ve
years) with some water
conditions, the sidearm will
clog up with scale (lime)
and restrict or shut off the
ow completely through
the sidearm.
Refer to “Installation
Manual”
Improper hook up of the
sidearm exchanger.
Refer to “Installation
Manual”
Water in Auger Tube
Condensation formation on
cooler steel.
Maintain constant rebox
temperature
Refer to “Ash Auger Tube”
Water Temperature doesn’t
correspond with controller
settings.
Inadequate rate of ow of
water allowing layering of
water temperatures.
Flow should be at least 15
gallons per minute. Check
pump and installation.
Refer to “Installation
Manual”
No contact paste applied
to well of Temperature
Probe and / or High Limit
Aquastat
Remove Temperature
Probe and well, apply
paste.
Refer to “Electrical (Tem-
perature Probe)”
Faulty Electronic Controller
Replace Electronic
Controller
Refer to “Electrical (Elec-
tronic Controller)”
Exccess Smoke Catalyst Plugged Clean Catalyst Refer to “
Catalyst not working Replace Catalyst Refer to “
Exccess Cycle Times Catalyst Plugged Clean Catalyst Refer to “
To Next Page
Loading...
