9
Electrical connection
The Electrical supply must correspond to that indicated on the appliance.
All supply cables have to be sized according to the appliance power and installation requirements.
Please refer to below table:
The above information is only a guide. Please refer to a qualified Electrician if in doubt.
Use the cable glands and grommets provided inside the heat pump to secure and route the supply cables.
Trial Running
After connecting the unit to the pool system, ensure your installation is complete, with a suitable by-pass
and electrical connections by a qualified engineer.
Be sure that:
1) Appliance is horizontal and on a firm base.
2) Water system has no leaks.
3) Electrical Installation is compliant with all local regulations and standards.
4) The installation requirements described previously have been strictly adhered to.
ATTENTION: THE HEAT PUMP ONLY OPERATES WHEN WATER FLOW IS PRESENT.
You can start up the heat pump following the procedure below:
- Open by-pass valves
- Start pool system pump
- Turn on pool heat pump
- Set controller
To Next Page
Loading...
Need help?
General