3
SAFETY INSTRUCTIONS
To prevent injury to the user, other people or damage to property, the following instructions must be
followed.
Install the unit only when it complies with local regulations, by-laws and standards. Check the main
voltage and frequency. This unit must be earthed and have a supply voltage of 220 – 240 V ~ / 50Hz.
The following safety precautions should always be taken into account:
- Be sure to read the following WARNING before installing the unit.
- After reading these instructions retain for future reference.
Installing the Unit.
Incorrect installation could cause injury due to fire, electric shock or water damage. If in doubt consult
your local dealer or a qualified installer.
Securing the Unit.
The unit should be located on a solid, level, horizontal surface and securely fixed. Ensure free air-flow to
all sides of the unit.
Electrical Connections.
Ensure the correct sized Circuit Breakers, isolators and cables are used. All terminals should be tightly
secured and not prone to stress.
This unit must be earthed.
Materials.
To prevent fire, electric shock and other hazards all materials should be suitable for the specific use of
this unit.
Never use an extension cable to connect the unit to the electric power supply.
If there is no suitable earthed supply available, have one installed by a qualified electrician.
Do not move/repair the unit yourself.
Before carrying out any maintenance, service or repair work, the product must be isolated from the
mains electrical supply. To prevent possible injury, only qualified engineers should carry out these
works.
To Next Page
Loading...
Need help?
General