15
Controller operations
1. Parameter checking and setting.
Press button for 10 seconds to enter the parameter checking interface, then press to
Enter the parameter settings. You can now adjust parameters value with . Then press to
save and switch to other parameter settings.
NOTES:
a) Press button for 10 seconds to enter parameter checking and adjusting status.
b) Press to switch to different parameter checking.
c) Press enter into parameter settings status, and change parameter value with ,
Press to save and switch other parameter settings.
d) Under parameter checking status, press to exit parameter checking status.
e) Exit parameters settings automatically if no operation within 5 seconds.
Parameter settings will be invalid if the power fails within 10 seconds when adjusting parameters.
2. button
Press directly to enter CLOCK settings. The icon will flash, then press to set Hour with
,press again to set Minute with ,then press to save and complete settings.
If no need to set CLOCK, or CLOCK settings completed, press directly to enter TIMER settings.
The icon will flash, then press to set Hour with ,press again to set Minute
with ,then press to save and complete settings. If not required, press to enter into
the next group of Timer Settings.
When enter into setting TIMER ON/OFF till the displaying shows“--：--”,then press to cancel
current TIMER settings.
NOTES:
1.2 Timers can be set but each Timer needs to a set ON/OFF time.
To Next Page
Loading...
Need help?
General