18 / 32
PL
SK
DE
EN
CS
HU
• Use power tools only with specifically designated battery packs. Use of any other battery
packs may create a risk of injury and fire.
• When the battery pack is not in use, keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects that can create a connection between
the terminals. Shorting the battery terminals together may cause bums or a fire.
• Handle batteries with care. In the case of improper care, chemical substances can leak from
the battery. Avoid coming into contact with this substance and if you do come into contact
with it, rinse the affected area under running water. If the chemical substance comes into
contact with the eye, immediately seek out medical attention. The chemical substance from
the battery can cause serious injury.
SERVICE
• Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
DEVICE-SPECIFIC SAFETY INSTRUCTIONS
• Do not use the device near other people - especially children - and pets. Stop working, while
remaining in the vicinity. At all times, allow the safety distance around 15 m. There is the risk
of throwing off stones and gravel, which can cause injury.
• Walk, never run.
• The device is designed for two-handed operation. Thumb and fingers must firmly hold
the handle. Never work with one hand. At work, always use the shoulder strap.
• Make sure that the cutting mechanism does not come into contact with stones, gravel, wire
or other foreign objects when starting and during the work.
• Beware of line cutter. It can cause severe injuries.
WARNING! B
Never attempt to stop the cutting mechanism with hand. Always wait until it stops
itself. The cutting mechanism continues to rotate after engine is switched off for
a few seconds
• Use only the original cutting line. Using metal line instead plastic is prohibited.
• Do not use the device for trimming grass, which is not present on the ground, eg. grass,
which grows on the walls, rocks, etc.
• Do not walk with the device turned on through the gravel road or path.
• Ensure that ventilation holes are not clogged.
• Stop and switch off the machine, when leaving the operation stand. Wait till all moving
parts stop and if it is necessary ensure the machine before moving.
• Before using, always visually inspect to see that the trimmer line, reel and any parts of
the cutting mechanism are not worn or damaged. Replace worn or damaged parts.
• Remove the battery
- Allways, when the machine is without supervision
- Before eliminating of blocking
- Before checking, cleaning or work on the machine
- After crash into another subject
- Allways, when the machine beginns vibrate unreasonably
- When transporting
To Next Page
Loading...
