23 / 32
PL
SK
DE
EN
CS
HU
C The cutting head starts turning as soon as the motor is started. Cutting elements
continue to rotate for some time after the motor is switch off.
1. To operate the machine, first press and hold the switch-on locking button (fig. 9A). Press
and hold the ON/OFF switch (fig. 9B) to switch the machine on.
2. To switch the machine off, release the ON/OFF switch.
• Switcher must not be blocked by anything. When you release the switcher, the engine
must be switched off. If the switch is damaged, you mustn´t use this device!
• Periodically remove the remnants of grass from string cutters. Cutting output might be
negative affected.
CONTROL
WORK SAFETY AND RESPONSIBLY
C Make sure that you stand and hold the device firmly with both hands. Do not mount
cutting head on the ground.
• Switch the device on before you approach cutted lawn.
• Cut only grass and weed. Mind roots and stumps, danger of tripping and fall.
• Work carefully and during the work pay attention not to endanger anybody.
• Follow the cutting head.
• Do not work with the brush cutter during usual time of silent hours.
• During cutting in high bush or weed should do minimum cutting height 15 cm. In this way
will not be endangered small animals e.g. hedgehogs.
WORKING WITH THE
TRIM
MER HEAD
• On small grass areas hold the machine under the angle of 30 degrees and evenly turn to
the left and right in half round movements. (fig. 15)
• The best results you reach if the grass is max. 15 cm high. If the grass is higher, it is
recommended to cut it several times.
• Cut long grass in layers from the top to the bottom.
• Do not cut moist or wet grass.
• If you cut around the trees, fence columns or other obstacles walk slowly around the object
and cut by the top of the string.
• Avoid contact with solid objects (stones, walls, fences etc.). The string would be worn too
quickly. For keeping the cutting head in correct distance use the edge of the protection guard.
C Caution! Do not lean the string trimmer head agaist the ground during operation!
Unnecessary loosening of the string would occur!
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from accidentally starting by removing the battery
To Next Page
Loading...
