hecht 1040 - Assembly and Startup; Inserting and Removing the Battery; Operation with Machine; Turning on - off

22 / 32
PL
SK
DE
EN
CS
HU
ASSEMBLY AND STARTUP
SAFETY GUARD ASSEMBLY
CAUTION! A
Be carefull when assembling line cutter. It can cause severe injuries.
Fix the safety guard onto the motor housing with 2 screws
(fig. 2A).
ASSEMBLY THE ADDITIONAL HANDLE:
1. Loosen the two bolts (fig. 3A) from a piece of curved steel plate (fig. 3B).
2. Position the second handle over the tube in the proper location.
3. Slide two bolts through the holes in the second handle and fixed on.
ASSEMBLY THE SHOULDER STRAP
Fasten the hook in holder (fig. 4A), contingently on tube shaft.
This belt provided quick-release mechanism
(fig. 5A). Press the both side of the release button
with one hand, the machine can be released quickly from the operator in the event of emergency.
INSERTING AND REMOVING THE BATTERY
C First read the instructions supplied with the battery and those supplied with
the charger before inserting the battery.
1. Only insert a fully charged battery.
2. With a slight pressure push the battery
(fig. 6A) into the battery holder up to the stop until
the battery sits firmly on the contact plug of the tool.
3. Do not use force when inserting the battery pack. If the battery does not slide in easily, it is
not being inserted correctly.
4. Make sure the latches on battery pack snap in place and battery pack is secured before
beginning operation.
5. To remove the battery pack press and hold the battery latch button
(fig. 7A).
6. Remove battery pack from the holder.
OPERATION WITH MACHINE
CAUTION! A
Always wear the shoulder strap when working with the machine. Before releasing
the strap always switch off the engine. Danger of injury!
Do not operate without protective shield. Before each use check the device function.
TURNING ON - OFF
CAUTION! A
Start the motor carefully according to instructions and with body parts, especially
feet well away from the work area.