hecht 1040 - Cleaning; Replacement of the Spool

25 / 32
PL
SK
DE
EN
CS
HU
Failure to follow the maintenance instructions and safety precautions may cause serious injury
or death. Always follow the procedures, safety precautions, recommended maintenance and
recommended checks mentioned in this manual.
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from being started incidentally. Remove the battery!
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
• Always make sure that all nuts and bolts are firmly tightened and make sure the machine is
in good working order.
• Keep the machine in good condition, if necessary change warning and instruction labels on
the machine.
• Always ensure that the ventilation openings are kept clear of debris.
• For safety reasons, replace worn or damaged parts. Only use original spare parts and
accessories. Parts not tested and approved by the equipment manufacturer can cause
unforeseeable damage.
• Repair and maintenance work other than described in this section, which are more
complicated, or it needs special tools, let it on our authorized service.
CLEANING
CAUTION! A
Never spray the product with water or expose it to water.
Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Keep the ventilation slots clean and free from grass.
3. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water. Never use aggressive detergents or solvents for cleaning. This can
cause irreparable damage to the product. The plastic parts can be eaten away by chemicals.
4. Wipe down the product with a slightly damp cloth or with brush.
5. Clean the cover of the machine, especially the ventilation holes.
REPLACEMENT OF THE SPOOL
C Never employ metallic lines. The use of such non-original parts can cause injuries to persons
and irreparable damage to the device and leads immediately to voiding of the guarantee.
1. Turn the device so that the cutting head is located at the top.
2. Press both of the cap release latch on the cap (fig. 16A) and boost up it out of the spool
holder.
3. Then remove the spool (fig. 16B) out.
4. Remove any dirt and grass from the spool and holder.