hecht 1040 - Storage; Transport; Troubleshooting

26 / 32
PL
SK
DE
EN
CS
HU
5. Take the spring into the spool holder.
6. Feed the two cutting lines through the eyelets of the spool holder. Make sure that the end
of the lines do not slide out of the spool slots.
7. Put the spool into the box.
8. Press the cap into the spool holder and lock into place by cap release latch.
C Warning! If the cutting lines protrude beyond the trimming blade, cut them off so
that they just reach the blade.
CAUTION! A
Never replace the cutting unit with metal parts and use only a mower (cutting heads
and cutting elements) that are suitable for use at the strimmer‘s operating speed
STORAGE
• Store the machine out of reach of children.
• Remove the battery from the machine before storage.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Use the original packaging to storage whenever possible.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
TRANSPORT
Turn the motor off and disconnect the mains plug. When transporting, be careful not to drop,
or otherwise shock the machine. For transport, the machine has to be fixed against slipping and
tipping over. Do not place objects on the machine.
TROUBLESHOOTING
CAUTION! A
You cannot rectify disorders that require more intervention yourself.
If you‘re unable to rectify the fault using the corrective measures described below,
contact a specialist garage, preferably an authorised service centre.
Improper handling can cause damage or serious injuries.